WNMG080408-MR7 TK1000 Insert Flang10.9M6x12Z SGS 12mm Ser 5Mb 3Fl

SGS 12mm Ser 5Mb 3Fl Carbide Bullnose Endmill 3-Flute End Mills – Ball End – Micrograin Solid Carbide – 30° Right Hand Spiral – Right Hand Cutting – Center Cutting

Notes: Offset same side

Side-hung-float style with provision for transfer tube and accelerator pump

M10 Din taps

koken 3/4"dr impact extension bar 330mm 16760 3/4"dr impact extension 330mm

WNMG080408-MR7 TK1000 Insert Flang10.9M6x12Z SGS 12mm Ser 5Mb 3FlTK1000 The most wear resistant grade for machining of grey and ductile cast iron. It is also an alternative in turning of hardened steels. Ti(C,N) + Al2O3 DURATOMIC MR7 Chipbreaker: The strongest chipbreaker for double sided inserts. The MR7 is suitable for high feed rates and depths of cut that normally require a single sided insert. The chipbreaker has a wide negative T land, which gives high edge strength. Indicative machining range: f = 0,350,90